|
55,00 EUR incl. 19% BTW |
|||
)
Manual Gate.
Module A-164-1 is equipped with 3 push buttons that are used to generate three separate manual gate signals (i.e. ~ +12V voltage output while button is operated, 0V when released). The gate number (1, 2, 3) is milled into the caps and white inked. Gate 1 is a bit different: provided that no plug is connected to the input socket it behaves like the other two manual gates (the socket is normalled to +12V via a protection resistor). If a control signal (e.g. rectangle output of an LFO) is fed into the input socket the gate button 1 is working as a momentary on/off switch that is used to turn the signal on/off that appears at the two output sockets (kind of mute function). Each Gate output has two sockets available (miniature multiple).
An internal jumper can be used to connect Gate 1 or Gate 2 to the gate line of the internal A-100 bus. That way the module can be used to control one or more envelope generators (e.g. ADSR A-140) that are connected to the same bus board as the A-164. The gate outputs are "smoothed" with 100nF capacitors to avoid contact bouncing. If Gate unit 1 is used to switch audio signals this capacitor should be removed as it works as a low pass filter for audio signals.
--------------------------------------------------------------------------------
Breite/Width: 6 TE / 6 HP / 30 mm
Tiefe/Depth: 20 mm (measured from the rear side of the front panel)
Strombedarf/Current: 10 mA
--------------------------------------------------------------------------------